Cli Common Task Reference; Setting Up The In-Band-Management (Ibm) - Trango Systems TrangoLINK GigaPlus User Manual

CLI Common Task Reference

Setting up the In-Band-Management (IBM)

Trango pre-configures the links with IBM already set up and enabled, with tagging off,
however it will typically be necessary to change the IBM IP addresses used to fit the
application management network . This section covers the setup of the IBM.
Display the IBM settings. In the example below the IBM is off.
(CLI-config)# ibm
IBM Enable:
IBM Tagging:
IBM Vlan ID:
IBM IP address:
IBM Netmask:
SUCCESS
Enable IBM using the settings preloaded.
(CLI-config)# ibm enable on
IBM enable:
SUCCESS
Change the IBM IP address and subnet mask. Each end of the link should have a
different IP address, and in the case of multiple daisy chained links, the IPs should all be
different.
(CLI-config)# ibm ip 172.16.1.2 255.255.255.0
IBM IP Address:
IBM netmask:
Trango Systems, Inc.
off
off
100
172.16.1.1
255.255.0.0
on
172.16.1.2
255.255.255.0
GigaPlus User Manual Rev 3.1
125