Trango Systems TrangoLINK GigaPlus User Manual page 127

change that would break the link will result in loss of control to the far side. Changes
to parameters like frequency, speed, or opmode should be done with care.
Return to the command line interface using the cli command. Upon returning from the
debug prompt, the system will be in the view node, so the user must log into the config
node if any further changes are required.
debug> cli
Trango System:
Return to the config node using the config command
(CLI-view)# config
Password:
IBM may function with VLAN tagging enabled or disabled. With IBM tagging on, a VLAN
must be used to access the radio via IBM. With IBM tagging off, traffic that is not tagged
with a VLAN will reach the radio via the data ports. While IBM can be used in either
method, Trango's recommendation is that IBM be used with a dedicated management
VLAN with the highest CoS setting on this VLAN to ensure critical management traffic is
never dropped due to traffic flooding conditions.
After changing the IBM tagging state, the config must be saved and the radio must be
rebooted for the setting to take effect.
(CLI-config)# ibm tagging on
IBM Tagging: on
(CLI-config)# config save
New configuration saved
SUCCESS
(CLI-config)# reboot
Trango Systems, Inc.
TrangoLINK GigaPlus Command Line Interface v3.0.0
GigaPlus User Manual Rev 3.1
127