Changing Password - Trango Systems TrangoLINK GigaPlus User Manual

The Command Line Interfaces keeps a history of commands used, pressing the up arrow
will display previous commands used. The CLI can supports auto-complete of a
command being typed by pressing <tab> key. If a command is partially typed followed
immediately by a "?" it will display all related commands.
Example:
(CLI-config)# ? (The ? will not be display)
targetrssi
tdm
telnetd
temp
tftpd
threshold
trap
(CLI-config)#
!
TYPE "?" FOR A LISTING OF ALL CLI COMMANDS

Changing Password

The debug and view node share the same password. The config node has a separate
password. The view and debug mode password is changed in the debug mode. The
config node password is changed in the config node. Use the CLI command passwrd to
change the password. The example below demonstrates changing the password for the
config node to "control"
Syntax: passwrd <newpassword> <newpassword>
Example:
(CLI-config)# passwrd control control (
If the command is properly executed, the system will return a "SUCCESS" and return to
the CLI-config prompt.
If the password is lost and the unit is locked, the pushbutton on the access panel can be
used to reset the password and default IP back to the factory settings
Trango Systems, Inc.
Set target RSSI level for ATPC
Display TDM configuration
Enable/Disable telnetd
Display IDU and ODU temperature
Enable/Disable tftpd
Set the threshold for the radio parameters
Display snmp trap management information
GigaPlus User Manual Rev 3.1
.
The password must be entered twice
)
56