4.0 Link Management; Overview - Trango Systems TrangoLINK GigaPlus User Manual

4.0 Link Management

This section describes the various ways to manage and monitor the health and
performance of the GigaPlus microwave backhaul link.

Overview

The GigaPlus can be managed through the following methods:
Graphical User Interface (GUI
Web Browser: Remote access via in band and out of band methods with two
level view and configuration level access using any standard web browser such
as Internet Explorer, Chrome, Firefox, and Safari .
Command Line Interfaces
SSH – Encrypted remote access via in band and out of band methods with
separate view and configuration level access (password protected)
Telnet – Remote access via in band and out of band methods with separate view
and configuration level access (password protected)
Console – Local Access using a serial cable for bench configuration with separate
view and configuration level access (password protected).
SNMP – Remote control and monitoring via in-band and out-of band methods
using any third party Network Management Software (NMS). See Appendix D for
details on the MIB and SNMP objects. Standard MIB II System Level and
Enterprise MIB Blocks are supported with monitoring for all major link health
and traffic related metrics.
Default IP Address
The factory configuration for IP address is 192.168.100.100 for all units, and the IBM
default address is 172.16.1.1 for the "A" side unit and 172.16.1.2 for the "B" side unit.
Default Passwords
The default passwords are shown in the table below:
Trango Systems, Inc.
):
GigaPlus User Manual Rev 3.1
50