Table of Contents
Advertisement
Installation Process
The standard procedure for installing the equipment is as follows:
1) Install antenna per antenna installation manual
2) Install GigaPlus Power Supply and IDU in rack
3) Install ODU on antenna at both ends
4) Install IF cabling and surge suppressors
5) Align antennas
6) Proceed to commissioning.
CAUTION: GigaPlus has no user serviceable parts. Only factory certified personnel
should make any changes or repairs to the units.
Preparing for Installation
Tools
The following tools are required for installation:
Adjustable Open Ended Wrench
LMR400 cable
N-Male connector for LMR400
LMR400 strippping tool or razor blade
LMR400 cable crimp tool
#2 Flat screwdriver
#2 Philips Head screwdriver
Stranded 18 AWG wire for power connection
Stranded 12 AWG wire for ODU and IDU ground connections
Wire Insulation strippers for ground and power wire
Terminal crimpers for ground and power wire
Trango Systems, Inc.
GigaPlus User Manual Rev 3.1
69
Advertisement
Table of Contents
Need help?
Do you have a question about the TrangoLINK GigaPlus and is the answer not in the manual?