Debug Node - Trango Systems TrangoLINK GigaPlus User Manual

Debug Node

This node is additional management port related settings and users enter the debug
node, by typing in the debug command from the config node. Users can re-enter the
view node by entering the cli command from within the debug node.
Debug Node Command List
cli N/A
exit N/A
help N/A
ping <ip address>
passwd <passeword>
route N/A
ssh <ip address>
syslog N/A
telnet <ip address>
uptime N/A
tg_reboot N/A
Trango Systems, Inc.
Used to Enter the CLI (trango-view) node
Exit out of the session (clean exit)
Display list of commands in the debug node
ping network hosts
Reset the main password into view node
Display the current system routing table
ssh into another host
print system log
telnet into another host
Display the current uptime and system load
Reboot radio
GigaPlus User Manual Rev 3.1
145