Trango Systems TrangoLINK GigaPlus User Manual page 55

Config Node: (CLI-config)#, This node is accessed by typing in the command
config from the view node. The system will prompt for a password and after
successful authentication, the config node is enabled. All configuration settings are
changed within the config node.
Any command entered without any parameters returns the current configured values
similar to "view" node.
Most configuration changes are applied immediately and do not require a reboot. All
config changes must be saved to FLASH memory by issuing the config save
command. This can be done after all the changes desired are made within a single
session
If the configuration is not saved, the system will restore the last saved settings after
reboot.
ALL CONFIGURATION CHANGES HAVE TO BE SAVED TO FLASH IN ORDER TO BE
PERSISTENT ACROSS A REBOOT. A SINGLE "CONFIG SAVE" COMMAND WILL
! SAVE ALL CONFIGURATION CHANGES
The operator can go back to the "view" node by using the exit command from the
config node.
Example:
CLI login: admin
Password:
Trango System:
v1.3.0
(CLI-view)# config
Password:
(CLI-config)#
(CLI-config)#exit
SUCCESS
(CLI-view)#
Trango Systems, Inc.
TrangoLINK GigaPLUS Command Line Interface
GigaPlus User Manual Rev 3.1
55