Parameterization Area - WAGO I/O-SYSTEM 750 Manual

4.1.1.5 Parameterization Area

In the parameterization area, the Bluetooth
pared for communication. This is described in further detail in the following
sections.
Changing and saving data
To change settings in the Bluetooth
the parameterization area. Altered settings are labeled with a change symbol
nally queried values of the module. To transfer the new values to the module,
click on the [Write] button. The change symbols will disappear.
In this writing process, the values of the module are first temporarily saved so
that clicking on [Restart] can delete the changes again. In this case, you
should update the graphic display of the values after restart by clicking on
[Read].
To save transferred value changes permanently (flash process) without chang-
ing the operating mode, click on [Flash]. You may also change the module to
another operating mode. When you do this, transferred changes are automati-
cally and permanently saved. For example, you can change the module over to
the communication operating mode (real-time) after completing configuration
under Net Forming. This will cause the altered configuration to be saved, and
the module attempts immediately to exchange data with the configured partner
devices.
Figure 24: Saving the configuration
WAGO-I/O-SYSTEM 750
I/O Modules
Configuring and Operating with WAGO-I/O-CHECK
. This indicates that the displayed values are no longer the same as the origi-
WAGO-I/O-CHECK
Preview for module's settings
[Save]
WAGO
Buffer for new settings (volatile)
[Flash] or change of operation mode
(when the configuration is completed)
Memory of module's settings (non-volatile)
Tools for Configuring and Operating
®
module is configured and pre-
®
module, adjust the values displayed in
[Read] or open
the dialog window
®
Bluetooth Module
Module's start-up
or restart
• 65
g064471e