WAGO I/O-SYSTEM 750 Manual page 75

The following displays are summarized under the header "Status"
(see Table 32):
Table 32: General status display
Status
Device Role
Operating Mode
Communication
Profile
Diagnostic State
Network Status
Under "Channel monitor", the transmission quality for each slot is displayed
(see Table 33):
Table 33: Status of transmission channel
Status
Slot No.
Connected
Bit Error Rate
WAGO-I/O-SYSTEM 750
I/O Modules
Tools for Configuring and Operating
Configuring and Operating with WAGO-I/O-CHECK
Value Description
Slave Device takes over the role of "slave"
Master Device takes over the role of "master"
(see also Appendix 6.3.5.20, "GetLocalDeviceRole")
Communication Device is in communication mode
(see also Appendix 6.3.3.2, "GetLocalOperationMode")
Real-time profile Device is in the communication profile "real-time"
Ad hoc profile Device is in the communication profile "ad hoc"
Ok No warnings/errors
Warning Warning
Error General error
Critical defect Critical error (for details see Appendix 6.3.6.1, "GetLo-
calDeviceStatus")
Ok Configured network is established.
Inconsistent Not all configured connections are established.
Defective Configured network is (still) not established.
(for details see Appendix 6.3.6.2, GetNetworkStatus)
[Start Diagnostics]
Start value monitoring
[Stop Diagnostics]
End value monitoring
Value Description
Slot _ Slot Number
Yes Connected
No Not connected
No No device configured for this slot
0 % No bit error occurred
0.1...10% Some bit errors occurred
> 10% High bit error rate
• 75