WAGO I/O-SYSTEM 750 Manual page 35

Fieldbus independent i/o modules bluetooth rf transceiver
Table of Contents

Advertisement

Bit
2.1.1.8.1.1.1
Connecting WAGO Devices and External Devices
Slaves are divided into two groups: WAGO devices and external devices. The
WAGO devices use the real-time profile and the connection over L2CAP. Ex-
ternal devices can be connected with the master using the ad hoc profile by
SPP profile or through PAN. Both groups are therefore administered in sepa-
rate tables, even if they must be considered together with regard to simultane-
ous connections. The table for WAGO devices can accept up to seven entries.
Up to six devices are administered for external devices. A maximum of seven
simultaneous connections can exist at the same time, independently of how
many devices are listed in the tables of authorized devices using their MAC
addresses (see Table 14 and Table 15).
Table 14: Differences between WAGO devices and external devices
Table
Protocols
Profile of the master for a
connection
Maximum number of
slaves/slots per master
Process image
Module bus (in bytes)
Data width of wireless trans-
mission
Initiator of the connection
WAGO-I/O-SYSTEM 750
I/O Modules
Value Description
0
Mailbox of the connected device covered
2
2
1
Mailbox of the connected device uncovered (warning of obsolete data)
0
No warning
3
2
Warning; e.g., if after the expiration of a defined time limit for warning mes-
1
sages, no packet has been received from the other party
4
2
0
Reserved (always 0)
0
Mailbox masked (confirmation of the bus module)
5
2
1
Mailbox unmasked (confirmation of the bus module)
0
Wireless connection is established
Warning of non-existence of process data or invalid process data, for example in
6
2
1
configuration mode, during a restart or in the case of an interrupted wireless con-
nection
During process data communication, always 0 (confirmation of the bus module)
7
2
0
(switch between process data communication and register communication)
WAGO devices
WAGO_DEVICE (0x20)
L2CAP
Real-time, ad hoc
7 (6 in the ad hoc profile)
10, 22, 46
(Process image – 2)
per slot, according to the
"cutoff"
Master
I/O Modules
Special Modules
External devices
EXTERNAL_DEVICE (0x10)
SPP, PAN
Ad hoc
6
device-specific
per slot, according to the "cut-
off"
Slave
• 35

Advertisement

Table of Contents
loading

Table of Contents