WAGO I/O-SYSTEM 750 Manual page 199

6.5.1.2.2 Configuration of the Bluetooth
1. Start WAGO-I/O-CHECK software (Version 3 or later).
2. Click on the [Identify] button.
Your node configuration is graphically displayed.
3. Click with the right mouse button on the Bluetooth
4. Choose Settings in the context menu. This opens a new window for the
Attention
In order to perform the following steps, the Bluetooth module must retain all
factory settings (default settings); i.e, you have not yet attempted any con-
figuration. If this is not the case, click on the [Default], button to reset the
module's configuration.
5. Click on [Data Frame] in the toolbar.
6. Enter (if not already set) a process image size of 48 bytes and a mailbox
7. Click on the [Read] button in the toolbar to update the view of the con-
8. In the list on the right side, assign the role of master to the module by
9. Choose the menu item Net Forming in the navigation bar.
The following section describes how to select the devices required to establish
a connection to the master. Devices that are visible for search requests can
first be searched for in a similar way to slave's configuration (see Section
6.5.1.2.1, steps 9-12). They may also then be stored using "Drag & Drop" —
an example being dropping and dragging from the search results into the list
of authorized devices (slots 1...13). However, for safety reasons, WAGO de-
WAGO-I/O-SYSTEM 750
I/O Modules
Example Configurations using WAGO-I/O-CHECK
would like to configure as a slave.
configuration of the module.
size of 12 bytes (see Figure 50).
Figure 50: Data Frame
figuration in the module.
choosing "Master" under Device Role.
®
Master using "Net Forming"
Appendix • 199
®
module that you
g064444e