WAGO I/O-SYSTEM 750 Manual page 204

204 • Appendix
Example Configurations using WAGO-I/O-CHECK
6.5.2.2.1 Switch the Mailbox on
1. Switch the mailbox of all modules on by setting the control byte to 0x20
Different error/warning bits can be set in the status byte depending on the de-
livery condition. The switched on mailbox is confirmed in byte 0 (status byte)
with 0x60: 60
Bit 2
active wireless connection.
Additional Information
The description of the control and status bit can be found in Section 2.1.1.8.1.1.
Table 36: Switching the mailbox on
Byte
PD/O
PD/I
6.5.2.2.2 Reset Modules to Factory Default
1. Reset all modules to the factory settings using the mailbox command "Set-
2. Wait five seconds after the execution of the command before continuing so
Table 37: Mailbox command "SetFactorySettings"
Byte
PD/O
PD/I
3. Execute the command "FlashRebootHost" (opcode 0x11) for all modules
4. Wait five seconds after the execution.
Table 38: Mailbox command "FlashRebootHost"
Byte
PD/O
PD/I
5
(bit 2 =1) (see Table 36).
= 0110.0000
hex
5
will confirm the switched on mailbox while bit 2
6 5
0x00 0x00
0x00 0x00
FactorySettings" (opcode 0x57) (see Table 37).
that the internal Bluetooth
6 5
0x00 0x00
0x00 0x00
(see Table 37) to restart them.
6 5
0x00 0x00
0x00 0x00
5 6
! bit 2 and 2 are set
bin
4 Toggle Opcode
0x00 0x00
0x00 0x00
®
subsystem can change over.
4 Toggle Opcode
0x00 0x00
0x00 0x00
4 Toggle Opcode
0x00 0x00
0x00 0x00
6
will display a still in-
empty
0x00 0x00 0x20
0x00 0x00 0x60
empty
0x57 0x00 0x20
0x57 0x00 0x60
empty
0x11 0x00 0x20
0x11 0x00 0x60
WAGO-I/O-SYSTEM 750
I/O Modules
C/S
C/S
C/S