Table of Contents
Advertisement
Functions
Simulating Inputs
To simulate input data, you can set alternative values that are used for the input instead
of the actual process data values. This allows you to test how the system (i.e., the prod-
uct and a connected controller) responds to specific inputs.
With digital inputs, you can simulate pin 4 and pin 2.
For IO-Link, you can simulate port 16 data bytes.
5.3 Monitoring Functions
The 765 Series modules have extensive internal sensors for measurement of:
• Temperatures
• Currents
• Voltages
The measurements are performed for the device and for pin 1, pin 2 and pin 4 of each
port. The measured values can be displayed in WAGO Webserver I/O Field. Alternative,
an OPC UA client can read out the measured values and display them.
In the module, the measured values are compared to limiting values, and an alarm is trig-
gered if they fall above or below a limiting value (e.g., a temperature limit). The device
can send this alarm:
• PROFINET: send alarm to controller
• OPC UA: send event to OPC UA client
The OPC UA client application can use the measured values, for example to implement
load management. You can find information on load management in section
Power Supply
5.4 Overload Protection
The product has internal overload protection for the output current. The output currently is
constantly measured and monitored for values exceeding the maximum.
If the measured output current exceeds the maximum value, the product reduces the cur-
rent or switches the corresponding loads off.
5.5 Parameterization Tools
5.5.1 Overview
There are several ways to set the product's parameters. The following table provides an
overview of the tools.
26
Product manual | Version: 2.1.0
8PORT IOL-B FLD PN DC 24V 2.0A
[} 34].
765-4102/0100-0000
8 Design
Advertisement
Chapters
Table of Contents
