WAGO I/O-SYSTEM 750 Manual page 22

22 • I/O Modules
Special Modules
2.1.1.7.1 Time Required for Initialization
Waiting times occur during the initialization of the module
(see Table 5):
Table 5: Waiting times during normal operation of the module
Waiting times for
Connecting to the first slave
Establishment of connection to a ready-to-receive slave
Successful establishment of connection by the master to another
slave
Unsuccessful attempt to connect to another slave
Inquiry
[1] if the slave is ready-to-receive at the conclusion of the master's boot process
[2] the master does not achieve a connection to the slave when attempted
[3] shorter in more than 15 found devices
2.1.1.7.2 Configuration and Communication Mode
The Bluetooth
the first operation. If the communication mode with the real-time or ad hoc
profile has already been selected via WAGO-I/O-CHECK, the module's mode
will be changed to the respective profile.
During startup of the module, the last configuration is the one loaded. If this is
not correct; e.g., in the case of an invalid memory structure, the configuration
is overwritten with the factory settings.
Note
The factory settings can also be reset using the mailbox command "SetFac-
torySettings". The individual values for the factory settings can be found in
Table 6.
During initialization, the general error bit 2
means that no mode has been received and there is no valid process data avail-
able. LED 1 lights up red during initialization (duration approx. 5s).
Once initialization is complete, the module takes on the last configured operat-
ing mode, and LED 1 changes to green. During first operation (factory set-
ting), the module will be in configuration mode following initialization.
In configuration mode, the settings of the module can be configured according
to the desired function, for example by using WAGO-I/O-CHECK. In this
mode, the module can search for other Bluetooth
range and is visible for queries.
®
module operates automatically in configuration mode during
Seconds
~ 5
2-3
2-3
3-5
up to 10.3
6
is set in the status byte. This
®
devices within reception
WAGO-I/O-SYSTEM 750
[1]
[2]
[3]
I/O Modules