WAGO I/O-SYSTEM 750 Manual page 206

206 • Appendix
Example Configurations using WAGO-I/O-CHECK
Moving forward, the return values (MAC addresses) of the master will be re-
vealed to the slaves and the return values of the slaves will be revealed to the
master.
6.5.2.2.5 Loading the MAC Addresses of the Slaves into the Device List of the
Master
1. In bytes 5 through 10 of the master, write the MAC address of the first
2. Using 0x20 (TABLE_ENTRY) in byte 4, indicate the first table entry in
3. Use the mailbox command "AllowRemoteDevice" (opcode 0x83) to load
Table 42: Mailbox command "AllowRemoteDevice"
Byte
PD/O
PD/I
4. In bytes 5 through 10 of the master, write the MAC address of the first
5. Using 0x21 (TABLE_ENTRY) in byte 4, indicate the second table entry in
6. Since opcode 0x83 has not changed, but the mailbox command is to be
Table 43: Mailbox command "AllowRemoteDevice"
Byte
PD/O
PD/I
7. In bytes 5 through 10 of the master, write the MAC address of the third
8. Using 0x22 (TABLE_ENTRY) in byte 4, indicate the third table entry in
9. Change the toggle byte to 0x00 to execute the mailbox command (opcode
®
Bluetooth slave (see Table 42).
which the MAC address is to be written.
the MAC address of this slave in the device list of the master.
10 9 8
0x00 0x06 0xC6
0x00 0x00 0x00
®
Bluetooth slave (see Table 42).
which the MAC address is to be written.
executed again with the MAC address entered under 4, change the toggle
bit to 0x80.
10 9 8
0x00 0x06 0xC6
0x00 0x00 0x00
®
Bluetooth slave (see Table 44).
which the MAC address is to be written.
0x83) again.
7 6 5
0x__ 0x__ 0x__ 0x20
0x00 0x00 0x00 0x00
7 6 5
0x__ 0x__ 0x__ 0x21
0x00 0x00 0x00 0x00
4 Toggle Opcode empty
0x00 0x83
0x00 0x83
4 Toggle Opcode empty
0x80 0x83
0x80 0x83
WAGO-I/O-SYSTEM 750
I/O Modules
C/S
0x00 0x20
0x00 0x60
C/S
0x00 0x20
0x00 0x60