WAGO I/O-SYSTEM 750 Manual page 24

24 • I/O Modules
Special Modules
2.1.1.7.2.1 Configuration Mode
Mailbox commands are used in configuration mode to configure the Blue-
tooth
and carried out, for example, with WAGO-I/O-CHECK or by using function
blocks of the WAGO-I/O-PRO CAA.
Additional Information
The mailbox commands for configuring the Bluetooth
in Appendix 6.1. In Section 3 and Appendix 6.5, the configuration is de-
scribed using WAGO-I/O-CHECK. The Bluetooth
of the WAGO-I/O-PRO CAA for configuring the module are contained in the
document "WAGO_Bluetooth_03.lib", is available online at
http://www.wago.com
WAGO-I/O-PRO ! 759-333 ! Additional Information ! Libraries.
Table 6 below contains the factory settings. These can be restored and saved
in case of altered configuration by using the mailbox commands "SetFactory-
Settings" (except for Bluetooth
by the assigned mailbox command.
Table 6: Factory settings for the Bluetooth
Parameter
Bluetooth
IP
Subnet Mask
Gateway
Device role
Operating mode
Mailbox
Encryption
Authentication
Standard password
Quality of Service (QoS)
Class of Device
Time for reconfiguration of connection
Authorized devices
Linked devices
Process image sizes of the up to 7 slaves in the
master
®
module for use. The commands are passed to the Bluetooth
under Documentation ! WAGO Software 759 !
®
device name
®
®
device name). A device name is overwritten
®
module
Setting
WAGO-750-644
192.168.0.2
255.255.255.0
192.168.0.1
slave
configuration mode
cascade
active
with password
0000
disabled
0x0020F8
30 seconds
none (all lists are initialized with "0")
none (all lists are initialized with "0")
10,0,0,0,0,0,0 bytes (used when changing
the device role to "master")
®
module
®
module can be found
-specific function blocks
WAGO-I/O-SYSTEM 750
I/O Modules