WAGO I/O-SYSTEM 750 Manual page 208

208 • Appendix
Example Configurations using WAGO-I/O-CHECK
6.5.2.2.6 Loading the MAC Address of the Master into the Device Lists of the
Slaves
1. Enter the MAC address of the master in bytes 5 through 10 of the first
2. For each slave, set byte 4 to 0x20 (TABLE_ENTRY).
3. Use the mailbox command "AllowRemoteDevice" (opcode 0x83) to load
4. Proceed in the same manner with the remaining slaves.
Table 46: Mailbox command "AllowRemoteDevice"
Byte
PD/O
PD/I
6.5.2.2.7 Binding the Slaves in the Master
1. Write the MAC address of the first Bluetooth
2. Set byte 4 to 0x20 (TABLE_ENTRY).
3. Use the mailbox command "BindRemoteDevice" (opcode 0x85) to load the
Table 47: Mailbox command "BindRemoteDevice" for binding Slave 1
Byte
PD/O
PD/I
4. Write the MAC address of the second Bluetooth
5. Set byte 4 to 0x21 (TABLE_ENTRY).
6. Change the toggle byte to 0x80 to execute the mailbox command (opcode
slave.
the master in the device list of the slave (see Table 46).
10 9 8
0x00 0x06 0xC6
0x00 0x00 0x00
of the master (see Table 47).
MAC address of this slave in the device list of the master.
10 9 8
0x00 0x06 0xC6 0x___ 0x___ 0x___ 0x20
0x00 0x06 0xC6 0x___ 0x___ 0x___ 0x00
10 of the master (see Table 47).
0x85) again.
7 6 5
0x__ 0x__ 0x__ 0x20
0x00 0x00 0x00 0x00
®
7 6 5
4 Toggle Opcode empty
0x80 0x83
0x80 0x83
slave in bytes 5 through 10
4 Toggle Opcode empty
0x00 0x85
0x00 0x85
®
slave in bytes 5 through
WAGO-I/O-SYSTEM 750
I/O Modules
C/S
0x00 0x20
0x00 0x60
C/S
0x00 0x20
0x00 0x60