WAGO I/O-SYSTEM 750 Manual page 36

Fieldbus independent i/o modules bluetooth rf transceiver
Table of Contents

Advertisement

36 •
I/O Modules
Special Modules
If WAGO and external devices in different modes are connected with a
WAGO master, the following guidelines apply for communication with each
other (see Table 15):
Table 15: Possible connection of a master with WAGO or external slaves
Master
Real-time profile
Ad hoc profile
In the master, slots 1 through 7 correspond to the entries in the table of
WAGO devices. In the ad hoc profile, slots 8 through 13 are added with the
table entries for external devices.
In the ad hoc profile, connections to a maximum of seven slaves are estab-
lished. Of these, a maximum of six can be (see Table 15) WAGO slaves and a
maximum of six can be external devices. By using up the tables for external
and WAGO devices, process image areas can be configured for up to 13 slots
in the master.
Note
When changing to the ad hoc profile, care must be taken that the real-time
device is not connected to slot 7. If a device with a "cutoff" greater than zero
is configured, slot 7 is filled with zeros in the process image.
In the slave, the process image always contains only one slot in which the con-
figured master is unmasked. The width of a slot is determined by the "cutoff"
of this slot.
Slave
WAGO BT module
Real-time profile
up to 7 devices
In the ad hoc profile, a maximum of 7 devices can be active at the
same time, but there are always 13 slots available for configuration.
WAGO BT module
Ad hoc profile
-
up to 6 devices
External device
-
up to 6 devices
WAGO-I/O-SYSTEM 750
I/O Modules

Advertisement

Table of Contents
loading

Table of Contents