Mailbox Command References - WAGO I/O-SYSTEM 750 Manual

102 • Appendix

Mailbox Command References

6.3 Mailbox Command References
In this section, the requirements for the execution of each mailbox command
are represented as follows:
Mailbox size (6, 12 or 18 bytes)
●
(●) Available to a limited extent
-
Operating mode (configuration mode/communication mode with real-
time or ad hoc profile)
●
-
Device role (master, slave)
●
-
Save configuration
●
-
Restart
●
-
Available
The command can be executed.
Execution of the command is possible, but only as much
data as is possible for the current mailbox size is returned.
Not available
The command cannot be executed.
Available
The command can be executed.
Not available
The command cannot be executed.
Available
The command can be executed.
Not available
The command cannot be executed.
With this command, module settings are changed. This change is first undertaken on a
temporary image of the module configuration. The temporary image is loaded during a
restart of the module from the non-temporary image. To update the non-temporary image,
execute a warm start (see Appendix 6.3.3.2, "FlashRebootHost"). Alternatively, you can
change the operating mode (see Appendix, "SetLocalOperationMode", 6.3.5.11).
This will automatically execute a warm start (see Figure 24).
No data is saved for this command.
The module executes a restart after performing command.
The module executes no restart performing the command.
WAGO-I/O-SYSTEM 750
I/O Modules