Commissioning; Parameterization With Wago-I/O-Check - WAGO 750 Manual

WAGO-I/O-SYSTEM 750
750-471 4AI U/I Diff Galv
7

Commissioning

7.1

Parameterization with WAGO-I/O-CHECK

The WAGO-I/O-CHECK software from WAGO Kontakttechnik GmbH & Co. KG
can be used to conveniently and completely configure and parameterize the I/O
module, including:
• Graphical representation of the bus node
• Display of the measured values
• Settings for the application
• Configuration of the I/O module operating modes
• Parameterization of module, channel and scaling settings
• Calibration of channels and adjustment of analog inputs
• Monitoring
You can obtain the WAGO-I/O-CHECK software on a CD under Item No. 759-
302. This CD contains all the application program files and an explanation. You
can find a description at the internet page at http://www.wago.com!
Save all your settings before you begin parameterization!
To be on the safe side you should always save all of your current settings in a
parameter file before you begin parameterization. This enables you to always
use the original values, should any parameters you are defining not be correct!
Behavior after Overwriting with WAGO-I/O-CHECK !
If WAGO-I/O-CHECK is used to overwrite a parameterization made with the GSD
file, the I/O module operates with the WAGO-I/O-CHECK settings until the 750-
333 and 750-833 Fieldbus Couplers/Controllers are restarted. After restart, the
I/O module is re-parameterized via PROFIBUS using the GSD settings.
All manuals and user guides at all-guides.com
Commissioning 49
Manual
Version 1.0.0