Parameterization Of The F I/O Module With The Wago Parameterization Tool - WAGO 750 Manual

54 Commissioning
7.3 Parameterization of the F I/O Module with the
WAGO Parameterization Tool
Check safety functions!
Before commissioning, all the specified effectiveness of all safety functions must
be verified.
Check the iParameter settings!
After the parameterization of the F I/O module, the parameters read back from
the F I/O module must be compared to the expected values and confirmed. The
new parameters take effect after being confirmed.
Protect against unauthorized modification of the iParameters!
As stated in ISO 13849-1, unauthorized modification of the iParameters must be
prevented. This must be accomplished by secure protection of the F PLC or a
secure application project.
Verify that the parameterization LED is illuminated!
After selecting the F I/O module, check that the F I/O module parameterization
LED is illuminated! A detailed description of indicators is available in section
"Device Description" > "Indicators."
Manual
Version 1.0.0, valid from HW/SW Version 01/01
WAGO I/O System 750
753-661/000-004 4FDI 24V PROFIsafe