Set Local Operation Mode (Setlocaloperationmode, 0X4A) - WAGO I/O-SYSTEM 750 Manual

6.3.5.11

Set Local Operation Mode (SetLocalOperationMode, 0x4A)

With call up, the operating mode and communication profile of the Bluetooth
subsystem are set. The call up is followed by a warm start of the Bluetooth
bus module in the chosen operating mode, saving any changes made to the
configuration.
Note
If an operating mode is chosen that has already been accepted by the module,
then the command is acknowledged with MBX_CMD_OK, but there is no
restart of the module. No changes made to the configuration are saved.
Conditions
Request
Byte
Arguments
Parameter
MBX_OPMODE_ID
MBX_COMMROFILE
_ID
WAGO-I/O-SYSTEM 750
I/O Modules
Mailbox size Operating mode/profile
6 12 18 Config.
● ● ●
7 6 5
2 2 2
0 MBX_SETLOCALOPERATIONMODE
1 T
2 MBX_OPMODE_ID
3 MBX_COMMROFILE_ID
Value
MBX_CM_OPMODE_CONF
(0x01)
MBX_CM_OPMODE_COMM
(0x02)
MBX_CM_OPPROFILE_REALTIME
(0x01)
MBX_CM_OPPROFILE_CONFIG
(0x02)
MBX_CM_OPPROFILE_ADHOC
(0x03)
Mailbox Command References
Real-
Ad hoc
time
● ● ●
4 3 2
2 2 2
-
Appendix
Device role
Save
config.
Master Slave
● ● ●
1 0
2 2
Description
Configuration mode (with
configuration profile only)
Communication mode
(with real-time profile or
ad hoc profile only)
Real-time profile
Configuration profile
Ad hoc profile
• 131
®
®
Restart
●