16 April '88
2. Tray Down Sensor and Positioning Switch Replacement
1. Open the side cover (1 screw).
2. Remove the top cover and rear cover (5 screws).
3. Remove the sensor bracket [A] (2 screws). (There is no need to discon-
nect the sensor connector.)
4. Remove the two post tops [B] (3 screws each).
5. Remove the tray bottom plate [C] (4 screws) taking care not to damage
the 6 guide posts [D].
6. "Move the tray drive motor assembly [E] (2 screws) to the rear to dis-
engage the tray drive shaft [F] from the wire drive pulley [G].
I
[ G ]
9-14
[ E l
J