Ricoh FT4430 Service Manual page 293

16 April '88
Install the mounting bracket
13 .
tray (2 screws, M4 x 6 each).
14 . Remove the 5 strips of shipping tape [B].
15 .
Reinstall the rear right side cover [C].
16 .
Place the large capacity tray in the cassette holder on the 2nd feed sta-
tion.
NOTE: Make sure that the rib of the tray side plate fits into the groove of the
cassette holder.
17 .
Open the side and top covers and
(2 screws, M4 x 10).
18 .
Disconnect CN226 and CN227, and set these connectors to the harness
clamp.
19 .
Connect the tray harness to the paper feed PCB [D] as follows:
* connector to CN 226
3p
* 4p connector to CN 231
* 7p connector to CN 227
[ B ]
(Type C, Chrome) on the large capacity
[A]
the
secure tray
9-10
to the 2nd feed station
[ B ]