Ricoh FT4430 Service Manual page 307

5. Remove the rear cover [A].
6. Connect the editor connector (8 pin) [B] through the docking hole [C] of
the DF.
NOTE: If the platen cover is installed on the machine, the connector should
be connected through the cutout in the docking hole cap as shown
on page 10-8.
7 .
.Clamp the editor harness [D] to the main board bracket with the nylon
wire clamp [E].
Reinstall the rear cover.
8
9 . Check the operation of the editor.
10 .
Fill out the New Equipment Condition Report.
10-5
16 April '88