Ricoh FT4430 Service Manual page 157

16 April '88
7. 2nd Scanner Drive Motor Replacement
Perform Steps 1 through 6 of "Lens Drive Motor Replacement."
Tape the 2nd scanner drive pulley [A] and the scanner drive wire as
1 .
shown to avoid the scanner wire coming off.
2 Remove the E-ring [B] from the 2nd scanner drive shaft and move the
pulley slightly in the direction of the arrow.
3 Disconnect the 2nd scanner drive motor connector [C] (6p; white) and
the nylon clamp [D] (1 screw).
4 . Remove the mylar [E].
5 . Replace the second scanner drive motor [F] from the front (2 screws).
[ A ]
[ F ]
5-10