Ricoh FT4430 Service Manual page 243

12. Install the original feed table [A] on the right side of the belt unit [B] (2
screws with washer). (Be sure to engage the 2 hooks [C] of the original
table with the docking holes [D] of the belt unit).
13 . Install the original table cover [E] under the original table (4 screws).
14 . Level the DF as follows:
a) Remove the DF grip plate [F] (2 screws).
b) Place 2 sheets of A3 (11" x 17") paper between the white belt guide
spacers [G] and the exposure glass.
c) Loosen the mounting screws of the right side magnetic catch [H]. Push
down the right side of the magnetic catch bracket [1], then tighten the
screws of the right magnetic catch. Repeat this process with the left
side magnetic catch.
d) Remove the 2 sheets of paper.
7-17
16 April '88