Cleaning Brush Replacement - Ricoh FT4430 Service Manual

16 April '88

Cleaning Brush Replacement

3.
1. Remove the cleaning unit drive gear [A] (1 Allen screw), the collar [B],
and the bushing [C] from the rear end of the cleaning brush shaft.
2. Remove the bushing [D] from the front end (1 E-ring).
3. Take out the cleaning brush [E] with the brush shaft holder [F] (1 screw).
4. Take the brush shaft holder off the front end.
5. Install the new cleaning brush and reassemble the unit.
Do not touch the new brush; handle only the shaft.
5-28
[ c l