Ricoh FT4430 Service Manual page 294

20 .
Clamp the LCT harness [A] to the base plate with the nylon wire clamp
[ B ] .
21
Install the pick-up roller assembly [C] on the feed roller shaft.
22 Install the gear [D] on the feed roller shaft.
23 .
Reinstall the feed roller [E] (1 snap ring [F]).
24
Make sure that the paper position feeler [G] is positioned as shown.
25
Reinstall all covers.
26
Stick the caution decal [H] on the copier rear cover.
27 . Check the operation of the Large Capacity Tray.
28 . Fill out the New Equipment Condition Report.
9-11
16 April '88