Ricoh FT4430 Service Manual page 276

16 April '88
Fix the two PCB mounting studs [A] on the main board and install the in-
8
terface board [B].
9 Screw the mounting
10 . Mount the sorter on the copier. Pass the harness through the access
hole.
11 .
Fix the sorter unit to the copier with the spacers [D] and two knob screws
[E] .
12
Connect the sorter ac harness [F] (free red 2P connector).
13
Connect the sorter dc harness [G] (CNI 02, free white 4P connector).
14 Secure the sorter ground wire [H] (1 screw with toothed washer).
15 .
Turn on DIP switch 1-4 [1] on the operation panel.
16 .
Mount the sorter covers and copier rear cover.
17 .
Peel off the panel cover [J] at the left end of the operation panel [K].
18 .
Set the Sort/Stack key top [L] and adhere the Sort/Stack key cover [M].
19 .
Check the sorter's operation and fill out the New Equipment Condition
Report.
studs [C]
into the docking hole.
8-12
A ]
c]
B ]
[ G ]
1