Ricoh FT4430 Service Manual page 222

5. Place 5 sheets of paper (A3 or 11" x 17") on the exposure glass.
6. Turn on the main switch and select the Auto ID mode, then enter "99"
using the numeral keys. Press the Start key after the copier warms up. ,
7. Adjust the Auto ID sensor by turning VR2 on the lamp regulator board.
NOTE: Adjust the Auto ID sensor after the 3rd copy cycle has been
completed.
8. Press the C/S key to stop the copier.
9. Turn off the main switch and DIP switch No 1-1 and No. 1-8, then reas-
semble.
5-75
16 April '88 ~