Ricoh FT4430 Service Manual page 155

16 April '88
10
Run the scanner drive wire over the pulleys in the following order:
1) Long end should be in the outer track (WP1)
2) Lower side (wire clamp [A])
3) Lower track (WP2)
4) Three and a half turns from lower to upper (Scanner Drive Pulley [B]).
5) Lower track (WP3).
6) Inner track (WP1).
7) Track (WP4).
Pull the ends of the wire together and join them with the tension spring.
11 .
(See the preceding page.)
12 . Rotate the scanner drive pulley and make sure that the scanner drive wire
moves smoothly and that there is no overlapping around the scanner
drive pulley.
NOTE: Step 12 is important! If overlapping of the scanner drive wire occurs,
then the trail edge of A3 (11" x 17") copies may be reduced.
6)
5-8
1
I