12 June 1987
REPLACEMENT AND ADJUSTMENT
1. Tray Down Sensor and Positioning Switch Replacement
Open the side cover and remove the front cover (2 screws and 1
1.
connector) and rear cover (4 screws).
Remove the top cover.
2.
3.
Remove the stopper bar assembly (2 screws).
4.
Remove the two (2) post tops and two paper guides (1 long and 2
short screws each).
Remove the tray bottom plate (4 screws).
5.
Move the tray drive motor ass'y (2 screws) to the rear to disengage
6.
the tray drive shaft from the wire drive pulley.
7-6