7. REPLACEMENT AND ADJUSTMENT
7.1 Tray Down Sensor and Positioning Switch Replacement
1. Open the side cover and remove the front cover [A] (2 screws and 1 connector) and the
rear cover [B] (4 screws).
2. Remove the top cover.
3. Remove the stopper bar assembly [C] (2 screws).
4. Remove the two (2) post tops [D] and the two paper guides [E] (1 long and 2 short screws
each).
5. Remove the tray bottom plate [F] (4 screws).
6. Move the tray drive motor ass'y [G] (2 screws) to the rear to disengage the tray drive shaft
[H] from the wire drive pulley [I].
10-15
31 August 1989