Registration Clutch Adjustment - Ricoh FT4430 Service Manual

April '88
16

8. Registration Clutch Adjustment

[ B ]
ADJUSTMENT STANDARD:
Remove the rear cover (2 screws).
1 .
2 . Take the adjusting collar [A] off from
screw).
3 . Loosen the screw in the lock collar [B] on the clutch which is to be ad-
justed (1 Allen screw).
4 . Place the adjusting collar next to the lock collar on the clutch shaft.
Position a 0.1 mm gap gauge [C] (Part number #52059101) between the
5 .
two collars.
6 . Push the collars and the thickness gauge back until the clutch presses
against the rear plate. Tighten the Allen screw in the adjusting collar.
7 . Remove the thickness gauge and move the lock collar against the adjust-
ing collar. Tighten the Allen screw in the lock collar.
0.1 mm (0.004")
5-42
the registration roller shaft (1 Allen