Ricoh FT4430 Service Manual page 311

14 . Clamp the editor harness [A] to the main board bracket with the nylon
wire clamp [B], then reinstall the rear cover.
15
Install the editor on the copier.
16 . Put the pressure sheet [C] on the exposure glass so as to align the image
area indicators.
Remove the seal.
17
18 .
Close the edifor to complete the installation of the pressure sheet and the
editor.
19 .
Check the operation of the editor.
20 . Fill out the New Equipment Condition Report,
10-9
16 April '88
B ]
[
A ]
[