Ricoh FT4430 Service Manual page 246

16 April '88
20. Secure the copier PCB plate (2 screws).
21. Fix the two PCB mounting studs [A] on the main board and install the in-
terface board [B]. (This is not necessary if a sorter is already installed in
the machine.)
22. Connect the 3 DF connectors.
a) Connect two fiber optic connectors [C] to the interface board as
follows, being careful not to damage them:
CN806 Brown CNI 03
CN807 Black CNI04.
b) Connect the DF harness connector [D] to the copier's ac 4P
connector.
23. Secure the ground wire [E] to the ADF right mounting bracket (1 ground
screw and toothed washer).
7 - 2 0