Feedroller/Frictionpadgapadjustment (Lstand 2Nd Feed Station) - Ricoh FT4430 Service Manual

Feed Roller/Friction Pad Gap Adjustment (lst and 2nd Feed Station)
9.
NOTE:
This procedure is required when replacing the friction pad.
1. Remove the pressure arm [A] (2 screws).
2.
Push down the friction pad holder [B] to make the gap between the feed
roller and the pad.
3. Measure the gap between the feed roller and the pad using a gap guage
[c]
4. If the gap is not within the adjustment standard, adjust the gap by turning
the cam roller [D].
Clockwise:
Counterclockwise:
NOTE: Do not adjust the flat screws [E] because they are factory pre-set.
The gap is decreased.
The gap is increased.
5-43
16 April '88