Ricoh FT4430 Service Manual page 310

16 April '88
9. Install the left hinge [A] and right hinge [B] on the editor (6 screws each).
10. Install the hinge bracket [C] on the hinges (2 screws).
NOTE: Use the screws which secure the platen cover to the copier.
11. Remove the rear cover [D] and remove the right docking hole cover [E].
12. Remove the cap [F] from the right docking cover using a small screw
driver as shown.
13. Connect the editor connector (8 pin) [G] through the docking hole and
reinstall the docking hole cover on the copier.
[ c l
/
[ D ]
10-8