Ricoh FT4430 Service Manual page 245

15 , Pass the DF interface harness [A] through the harness hole [B] of the DF
and the docking hole of the copier [C].
16. Connect the DF interface harness to the DF PCB [D] (3 connectors).
NOTE: The fiber optics connectors [E] have different colours. Be sure to
match these colours when making these connections.
17 . Secure the DF ground wire [F] on the DF base plate (1 ground screw and
toothed washer).
18 . Pass the Ty-wrap [G] through the hole of the vinyl tube of the DF har-
ness, and then bind the vinyl tube to the bracket as shown.
19 . Open the DF and install the nylon harness bushing [H] from the under-
side. (This harness bushing should be positioned around the vinyl tube [1]
of the DF harness as shown. )
7-19
16 April '88