Ricoh FT4430 Service Manual page 194

10
Remove the hot roller gear [A], bearings [B], and the collars [C] from
9
both ends of the hot roller [D] (1 C-ring each).
Slide the hot roller slightly to the rear and remove the hot roller as shown.
11 .
12 .
Tear the protective paper [E] from the ends of a new hot roller and install
it.
13 w
After the new hot roller is installed, remove the protective paper.
NOTE: When reinstalling the fusing lamp, make sure it does not touch the
inside of the hot roller.
5-47
16 April '88