Replacementand Adjustment; Tray Wire Replacement - Ricoh FT4430 Service Manual

16 April '88
REPLACEMENT AND ADJUSTMENT
1• Tray Wire Replacement
/
- Front Wire -
1. Remove the following parts:
1) Front cover (2 screws and 1 connector)
2) Nylon clamp holding the operation board harness (1 screw)
- Rear Wire -
1. Remove the LCT from the copier.
2. Remove the following parts:
1) Rear cover (5 screws)
2) Transformer assembly [A] with tray main board [B] (1 screw, 8
connectors, and 1 nylon clamp)
3) Drive motor assembly [C] (2 screws and 1 connector)
4) Ac power terminal [D] (2 screws and 1 ground wire)
5) Safety switch assembly [E] (2 short screws)
6) Safety switch actuator assembly [F] (2 E-rings)
7) Shield plate [G] (4 screws)
Unplug the tray power supply cord.
9-12
A
>