Ricoh FT4430 Service Manual page 306

16 April '88
4. Installation Procedure on a Table
NOTE: This procedure is required if the ADF or platen cover is already
installed on the machine.
1. Turn the stylus harness [A] twice around the ferrite core [B] as shown in
the figure.
NOTE: Step 1 is only required in the European machines,
2. Plug the stylus jack into the editor board as shown.
3. Remove the screw securing the bottom plate as shown and secure the
lock plate [C] to the bottom plate.
NOTE: - Step 3 is only required in the European machines.
- Be sure that the lock plate does not damage the stylus
harness.
4. Place the editor on a table.
[ c l
10-4
\