Ricoh FT4430 Service Manual page 296

[ ' B ]
- Common Procedure for Front and Rear Wires -
NOTE:
The running directions for the front and rear wires are opposite.
Loosen the wire tightener [A] (1 screw).
1
2 Insert the bead [B] (unmarked) into the rear slot of the drive pulley.
Loop the wire around the drive pulley [C], as shown (one and a half
3
turns).
4 . Run the wire over WP1, WP2, WP3, and WP4 in turn while also placing
the lift rod's ends in the braces.
5 8 Insert the bead [D] (red) into the other slot of the drive pulley.
Loop the wire around the drive pulley, as shown (two and a half turns).
6
7 . Hook the wire on the tightener pulley [E].
8 .
Move the rods up and down manually to ensure that the drive wire does
not overlap on the pulley.
9 Tighten the wire using the tightener (1 screw).
10 .
Reassemble.
[ E ]
9-13
16 April '88
[ ~