Ricoh FT4430 Service Manual page 309

[ B ]
[ E ]
[ B ]
4. Install the clamps [A] on the editor as shown in the figure.
5. Turn the stylus harness [B] twice around the ferrite core [C].
NOTE: Step 5 is only required for European machines.
6. Plug a stylus jack into the editor as shown.
7. Remove the screw securing the bottom plate and secure the lock plate
[D] to it.
-
NOTE: - Step 7 is only required in the European machines.
- Be sure that the lock plate does not damage the stylus harness.
8. Secure the stylus harness and connector harness [E] in the clamps.
[ c l
[ D ]
10-7
16 April '88
[ D ]