Side Registration Adjustment - Ricoh FT4430 Service Manual

4. Side Registration Adjustment

NOTE: Do not move the paper size dial while performing this adjustment.
Do steps 1 to 8 of the tray down sensor replacement procedure.
1 .
2 .
Loosen the 2 screws securing the pinion bracket [A].
3 .
Loosen the screw securing the guide post lock plate [B].
Move the pinion bracket while holding the pinion so that the pinion does
4
not turn. (The front and rear guide posts must be equidistant from the
center.)
5 Tighten the screws securing the pinion bracket.
6 . Tighten the screws securing the guide post lock plates.
7 . Confirm that the side registration is adjusted correctly and reassemble.
9-17
16 April '88