Ricoh FT4430 Service Manual page 252

16 April '88
[ F
5 . Remove the two snap rings [A] fixing the feed-in guides [B].
6 . Remove the feed roller drive gear [C] (1 E-ring [D], 1 bearing [E]).
7 . Remove the collar [F] (1 Allen screw [G]) and the bearing on the front
feed roller shaft [H].
8 . Stand the feed roller unit [1] and slide the feed-in guides as shown in the
figure.
9 . Then slide the unit to the rear, lift the front of the unit, and remove it from
the DF.
7-26