Ricoh FT4430 Service Manual page 180

16 April '88
[ F ]
9 # Set new pick-off pawls [A] on the shaft [B] and position them with the
positioning pins [C] and pawl springs [D].
Assemble the pawl shaft assembly and set it on the cleaning unit sliding in
10 .
the rear end of the shaft to the rear side plate.
NOTE: -
When installing the cam holder [E] and the cam rider [F], align X
with Y as shown in the figure.
- Make sure that the spring end is in the small hole on the rear side
plate.
Install the pawl shaft pin [G].
11 .
12 9 Push the spring collar [H] to the rear and rotate it with one turn as shown
in the figure. Then set the collar on the pin.
NOTE: Make sure that the end of the spring is correctly positioned in the
groove of the collar.
13. Reassemble.
I
[ B ]
[ A ]
5-32
I