Replacement And Adjustment; Df Belt Replacement - Ricoh FT4430 Service Manual

16 April '88

REPLACEMENT AND ADJUSTMENT

1.

DF Belt Replacement

1. Remove the DF cover (4 screws, 2 collars).
2. Remove the 2 screws securing the left side of the front stay [A] and
remove the 3 belt unit holders [B].
3. Raise the left end of the front stay and set it in the up position with the
lock plate [C].
4. Rotate the belt release bracket [D] counterclockwise and lower the
original entrance guide [E].
5. Lower the DF grip bracket [F] and release the belt [G] from the belt guide
spacers [H].
6. Slide off the DF belt [G] and replace it.
NOTE: -
After installing the DF belt, make sure that the belt is properly
positioned in the belt guide spacers.
- When returning the DF grip bracket to its original position, make
sure that the DF grip bracket is properly set behind the flathead
screw.
7-22
1
[ F ]