Table of Contents
Advertisement
Receiver and Transmitter Names
In addition to renaming a device, individual transmitter and receiver channels can be
renamed in Dante Controller. Rename transmitter and receiver channels to reflect the
location of the device or the purpose of the transmitter or receiver. Ensure transmitter and
receiver channels are renamed before making audio connections between devices. Refer to
Renaming a Receiver or Transmitter
Dante Controller Naming Conventions
Device names follow Domain Name System (DNS) hostname rules. Legal characters are
•
,
A-Z
a-z
hyphen (
•
Dante Tx and Rx channel names (also known as labels) can be up to 31 characters in
length. Label names are not case-sensitive. For example, "
out-1
" are recognized as the same name. Unicode and non-roman characters are not
supported.
•
Tx and Rx channel labels can use any character except equals (
Tx and Rx channel labels must be unique on a device but do not need to be unique on
•
the network.
Renaming the XMP 240 C AT in Dante Controller
NOTE: Dante device naming can also be done via DSP Configurator (see
on page 86).
1.
Ensure that the control computer and a single XMP 240 C AT are connected to the
same network.
2.
From the control computer
All Programs > Audinate > Dante Controller > Dante Controller
3.
The
Dante Controller - Network View
network are discovered and listed.
4.
From the
figure 121).
Figure 121.
,
, and hyphen (
). Names must begin with a letter and cannot end with a
0-9
-
).
-
menu select:
Start
menu, select
Device
Device View
Opening Device View
on page 93 for renaming procedure.
ANALOG OUT-1
screen opens. All Dante devices on the
or press <
> on the keyboard (see
Ctrl+D
XMP 240 C AT • Dante Controller
" and "
analog
), period (
), or
.
=
.
@
Dante Device
91
Advertisement
Table of Contents
